Anolis ArcLine 6 User Instructions

The module generate colored light by means of Luxeon LEDs.The product was designed to use with the
ArcPower drivers and for indoor use only.
1.Attention
Do not install the module near high inflammable liquids or materials
Do not allow anything to rest on the module
Do not use the module near high humidity or water or expose to the rain
Do not install the module near the naked flames
Do not install the module in dirty,dusty or badly ventilated location
2.Installation
The ArcLine unit should be connected to the ArcPower driver according to the LED colour
variants (RGB,WW,CW...).
See the ArcPower 36/72/144/360/384 R.M./16x6/16x12 (or their smartwhite variants) user manuals for full
details of mains power requirements and DMX operation.
ArcLine units are supplied with 1.5 m of cable for direct connection to the ArcPower drivers.
Avoid looking directly into the LED light beam at close range!
Maximum possible number of LED modules connected to the one ArcPower 36 (or one LED output of the
ArcPower 72/144/360) is mentioned in the table below.
Total
Module
LEDs
(colour variant)
ArcLine 6 RGB
ArcLine 6 CW
ArcLine 6 WW
User instructions
Red Green Blue
LEDs LEDs LEDs
6 2 2 2
6 - - -
6 - -
ArcLine 6
CAUTION!
Cool Warm
Amber
white white
LEDs
LEDs LEDs
- - -
- 6 -
- - 6
1
Max.number
Compatible power
of connected
supplies
modules
ArcPower 36/72/144/360/
6
/384 R.M./16x6/16x12
ArcPower SmartWhite 36/72
6
ArcPower SmartWhite 144/360
ArcPower SmartWhite 36/72
6
ArcPower SmartWhite 144/360