Arctic Cat ZR 120 2017 Service Manual page 32

NOTE: Note the location of the cable tie for assem-

bly.
5. Rotate the throttle cable lever of the governor control
arm to the wide-open position and route the cable
end out of the arm; then loosen the throttle cable jam
nuts and remove the throttle cable.
0744-922
6. Inspect the throttle cable for damage or fraying.
INSTALLING
1. Route the cable through the slot in the throttle con-
trol and insert the cable into the throttle control.
Secure the cable with a C-clip.
A981
2. Seat the cable drum into the throttle lever recess;
then secure the throttle lever to the throttle control
with a pin and C-clip.
A980
3. Place the throttle cable into the throttle cable bracket
and secure with jam nuts.
4. Slide the end of the throttle cable into the throttle
cable lever.
5. Secure the throttle cable to the steering post with a
cable tie; then install the handlebar pad.
6. Open and close the throttle lever to make sure of no
binding or sticking.
 NOTE: At this point, adjust the throttle cable (see
Throttle Cable in the Carburetor sub-section).
ADJUSTING
To adjust the throttle cable, see Carburetor – ADJUST-
ING sub-section.
31