Atdec TELEHOOK 12/30 Multi Installation Instructions

Installation Instructions

TELEHOOK
Component Checklist
Secondary Arm
200mm (x1)
Swing Arm
(x1)
200mm VESA
Plate (x1)
Bits Box
14 Gauge Coach Screws (x2) 6mm Allen Key (x1)
M8x 115mm Bolt (x1) 4mm Allen Key (x1)
Installation Procedure
! IMPORTANT - Install Telehook Multi as per Installation Instructions.
! Telehook Multi supports Displays from 12" (30cm) to 30" (76cm) weighing up to 18kg (39lbs).
! The Manufacturer accepts no responsibility for incorrect installation.
A Check Components
Check you have received all parts against the Component Checklist and Bit Bag above.
B Choose your Mounting Option
Select which mounting option is best suited for your application.
Note that the Telehook 12-30 Multi comes packaged as the Swing Arm by default. (Option 1.)
Option 1: Swing Arm
Wall
12/30 Multi
Swing Arm Components
Yoke (x1)
Wall
Cover
M8 Cap Screw (x1)
Plate (x1) Bracket (x1)
M8 Square
Primary Arm 230mm (x1)
Neck Bolt (x2)
Steel
Double Sided
Push In Clips (x3) Washers (x2) Washers (x2)
Bush (x1)
M4 x 10mm M4 x 12mm
M8 Nyloc (x1) Nylon Anchor Plugs (x2)
Screws (x6)
ISOMETRIC VIEW
Follow Steps; C, D, F & J
Option 2: Articulated Arm
75/100mm VESA
Plate (x1)
Wall
Option 3: Wall Mount
One Sided
Bush (x4)
M8 Nyloc's (x2)
Plastic
M6 x 12mm
Screws (x6)
M4 x 16mm
Screws (x6)
Screws (x6)
Wall
Follow Steps; G, H, I, & J
Options 1 & 2 (Swing Arm & Articulated Arm)
C Installing the Wall Bracket
NOTE! You must remove the Wall Bracket from the Swing Arm before Installing
C.1 Mounting to a timber stud wall
- Position Wall Bracket vertically on the wall and mark the 2
mounting holes. (Use a Spirit Level)
- Drill 2x50mm(2") holes using a 3mm(3/16") drill bit.
- Secure the Wall Bracket using the supplied 14 Gauge Coach
Screws.
- Attach the Cover Plate as shown in diagram C.1.
C.1.
Stud
Wall
Material
Follow Steps; C, E, F, & J
Horizontal Correction of Display
If the display does
not sit horizontally,
loosen the screw
shown on the
back of the yoke
using the 4mm
Allen Key.
Re-tighten screw
firmly when
display is
positioned
horizontal.
C.2 Mounting to a masonry wall
- Position the Wall Bracket vertically on the wall and mark the 2
mounting holes. (Use a Spirit Level)
- Drill holes using an 8mm masonry drill bit.
- Secure the Wall Bracket using the supplied 14 Gauge Coach
Screws and Nylon Anchor Plugs.
- Attach the Cover Plate as shown in diagram C.2.
Wall Bracket
Cover Plate
2x14 Gauge
Coach Screws
Adjust Angle
Loosen
Screw
4mm Allen Key
C.2.
Wall Bracket
Cover Plate
2x Nylon
Anchor Plugs
2x14 Gauge
Coach Screws
Masonry Wall