Sd Card Removal - Dell S4810 Installing Manual

recycling and recovery of WEEE. Customer participation is important to minimize any potential effects
of EEE on the environment and human health due to the potential presence of hazardous substances in
EEE.
Dell Force10 products, which fall within the scope of the WEEE, are labeled with the crossed-out
wheelie-bin symbol, as shown above, as required by WEEE.
For information on Dell Force10 product recycling offerings, see the WEEE Recycling instructions on
iSupport at: https://www.force10networks.com/CSPortal20/Support/WEEEandRecycling.pdf.
For more information, contact the Dell Force10 Technical Assistance Center (TAC) (see
Technical Assistance Center).

SD Card Removal

To support high security environments, you can remove and re-install the SD card. Dell Force10
recommends removing the SD card only when necessary. The SD card must be removed and replaced by
authorized personnel only.
CAUTION: Only remove the SD card to support high security operations and after discussions with Dell
Force10 Technical Support or your Dell Force10 representative.
To open the case and remove the SD card, follow these steps:
Step Task
Remove the small Phillips screws that connect the top of the case to the body. There are three screws evenly
1
spaced across the rear and three screws evenly spaced along each side.
Slide the top backwards until its front flange slides free of the faceplate then lift it off.
2
Remove the three larger Phillips screws and carefully lift off the CPU card. The SD card is located on the
3
underside of the CPU card.
Gently push the SD card to release it from the slot.
4
Contacting the
Specifications | 47