21.Slot Suit
Select On or Off
※Chan Set (Analog Channel)
When the channel type is analog, it will auto hide the digital menus, instead, the
channel set will show the analog menus.
The below listed menus are for analog channel only, other not listed menus are same
as the digital channel.
4.TCDT
Set up the CTCSS/DCS code for the TX.
5.RCDT
Set up the CTCSS/DCS code for the RX.
6.RTCDT
Set up the CTCSS/DCS code for both TX and RX CTCSS code: 62.5Hz~254.1Hz, a
total of 51 groups DCS code: 000N~7771, a total of 1024 groups.
7.Optional Signal
Allows the set up of DTMF/5TONE/2TONE encode and decode for the analog
channels.
9.Squelch mode
When the analog channel is set up for both CTCSS/DCS decoding and optional
signaling, you can set up the RX condition in this menu.
SQ: You can hear the call when the channel receives a matched carrier.
CDT: You can hear the call when the channel receives a matched CTCSS/ DCS signal
TONE: You can hear the call when the channel receives a matched signaling.
C&T: You can hear the call when the channel receives a matched CTCSS/ DCS and
matched tone signaling.
C|T: You can hear the call when the channel receives a matched CTCSS/ DCS or
matched signaling
10.Band Width
Choose wide band or narrow band for the analog channel.
26