BRAX NOX4 DSP Instruction Manual page 9

4 CPS - Colour Protection System
Red (12) = overheated: If the amp shuts off due to overheating it will take some time (depending on the outside tempera-
ture) until it turns on again.
5-6 Connectors for a BRAX Power Stabilizer
If a BRAX Power Stabilizer is connected to this terminal peak loads in the power supply will be eliminated. Thus, the am-
Equipment and control units
7 Loudspeaker terminals
To connect the speaker cables. Never connect the loudspeaker cables with the car chassis ground. It damages your
All speaker systems must be connected in-phase, it means plus to plus and minus to minus. Inverting plus and
minus will result in the loss of bass rendition. The positive terminal is marked on most speakers.
8 USB-Port
USB port and the PC-Tool software.
9 MicroSD card reader
containing all DSP settings. The se
has been copied the card must be removed.
Attention: Do not remove the MicroSD card during copying.
button (10) to toggle between them.
Please note:
24