Related Manuals for BRAX X 2000.2 GRAPHIC EDITIONS
Summary of Contents for BRAX X 2000.2 GRAPHIC EDITIONS
- Page 1 X 2 0 0 0 . 2 X 2 4 0 0 . 2 G R A P H I C E D I T I O N S B E D I E N U N G S A N L E I T U N G I N S T R U C T I O N M A N U A L...
-
Page 2: Table Of Contents
Equipment features and control elements X2000.2 ..11 - 12 Within just a few years, we have succeeded in giving the BRAX brandname Connection of speaker- and power cables X2000.2 ... . . 12 world wide recognition. -
Page 3: Connection X2000.2 / X2400.2
5 m, we advise a figure of max. 5 A per mm For the X 1000 and X 1400 BRAX amplifiers described and for the X As already mentioned, the negative lead from the vehicle battery to the... -
Page 4: Equipment Features And Control Elements X2000.2
4 Input Sensitivity Level Controller Position 2 - BRIDGED-STEREO: If the amplifier operates in Mono mode the The level controller enables the input sensitivity of the BRAX amplifiers switch has to be set on Bridged position. In this case both channels works as one to be adapted to the output voltage of the connected control unit (Mono) channel. -
Page 5: Connection Of Speaker- And Power Cables X2000.2
Fig. 8 Example: Lowpass 250 Hz - 4500 Hz 12dB/octave Fig. 10 Example: Highpass 250 Hz - 4500 Hz 12dB/octave variabel variable 250 Hz 4,5 kHz 250 Hz 4,5 kHz 13 Highpass Frequency Selector 14 Control for frequency range Lowpass To switch the control range of the potentiometer (15) from 15 Hz to 300 Hz and To adjust the crossover frequency from 15 Hz to 4,5 kHz. -
Page 6: Equipment Features And Control Elements X2400.2
6 Input Sensitivity Level Controllers 15 Control for frequency range Highpass The level controllers enable the input sensitivity of the BRAX amplifiers To adjust the crossover frequency from 15 Hz to 4,5 kHz. to be adapted to the output voltage of the connected control unit (radio/tuner). -
Page 7: Connection Of Speaker- And Power Cables X2400.2
If a subwoofer is connected we recommend to use highpass control 20 Fig. 18 Mono-Stereo Selector as variable subsonic filter or to turn control 20 counter-clockwise to To set the operating mode of the amplifier. 15 Hz to get a subsonic filter. Position 1 - STEREO: If the amplifier operates in 4-channel mode the switch has to be set on “stereo”... -
Page 8: Troubleshooting
Parasitics in the cinch cable. Check the connections (screen/shield). Interference noise Parasitics in the power supply cabling. Replace the cable with screened BRAX POWER TRAX cable. Consult your from the engine. dealer. Feedback interference from the chassis to the control Select an optimum central ground point to serve the entire power supply unit (radio/tuner). - Page 9 AUDIOTEC FISCHER GmbH Hünegräben 26 57392 Schmallenberg/Germany Tel.: +49 2972 9788 0 Fax: +49 2972 9788 88 info@audiotec-fischer.com www.audiotec-fischer.com...