BRAX NOX4 DSP Instruction Manual page 11

Connecting a computer and installing the software
supplied USB cable. The current PC Tool version is always on our homepage
Tool" section of the top menu. We recommend regularly checking before each use of the software for versi-
on updates. Note that PC-Tool version updates mean that the DSP operating software must also be updated.
Important: Make sure the NOX4 DSP is not connected to your PC prior to software installation. Connect and use it only
after the software has been completely installed on your computer. To ensure fault-free operation, always use the latest
PC Tool version available.
Software installation:
1. Download the software from the homepage previously mentioned from the „PC-Tool" section to your computers hard drive.
2.
thumb drive - it must be saved on the hard drive.
3.
Rev X-xx.exe" program is started. Note: The installation may last up to one minute.
The software is ready for use once the driver installation is completed. The NOX4 DSP can now be connected to the computer
have an inherent risk of damage even at low volume.
Comprehensive operating instructions for the HELIX DSP PC Tool can be downloaded at
26
Important: This folder must not be on a portable storage device such as a USB
MUST be done before the „PC-Tool
-