scope Digilink MK3 Installation & User Manual page 3

Digilink MK3, USA Mains Version
Preface
Important Safety Information
Removal of covers from the equipment must only be undertaken by authorised service personnel,
who must ensure that power is isolated prior to removal.
Installation
Installation must only be undertaken by an Approved contractor, who shall ensure that all work is
carried out in compliance with the appropriate State and Federal Regulations. This equipment must
be earthed. For mains powered equipment, a readily accessible isolating fused spur must be located
within 1 meter of the equipment.
Liability
Scope does not accept liability for any damage or injury, howsoever caused as the result of misuse of
this equipment. It is the responsibility of the user to ensure that the equipment is operated in the
manner for which it was intended and that it is the correct item of equipment for the required task
Warranty
This product is warranted as free from defects of workmanship and materials for a period of one year
from the original purchase date. During this time, if there is a defect or malfunction of this product,
Scope will, with proof of purchase, repair or replace at its discretion any defective parts, free of
charge. This does not include where the adjustments, parts and repair are necessary due to
circumstances beyond the control of Scope, including but not limited to fire or other casualty,
accident, neglect, abuse, abnormal use or battery leakage damage.
There are no other expressed or implied warranties except as stated herein, and those excluded
include those of merchantability and fitness for a particular purpose. In no event will Scope or any of
its agents be liable for direct, indirect, special incidental or consequential damages resulting from any
defect in the product, even if advised of the possibility of such damages.
The warranties and remedies set forth above are exclusive and in lieu of all others, oral or written,
expressed or implied. No Scope distributor, dealer, agent or employee is authorized to make any
modification, extension or addition to this warranty.
Some states do not allow limitations on how long an implied warranty may last and some states do
not allow exclusions or limitation of incidental or consequential damages.
No User Serviceable Parts
Alteration or modification to any part of this equipment, without the prior written consent of the
manufacturer, will invalidate all Approvals and Warranties attaching to the equipment. Further
liability for the operation of the equipment, under the applicable law, will pass to the user, who will
absolve the manufacturer of any further responsibility for it's correct operation and use.
Caution! RF exposure requirements: this product should be installed so as to ensure a separation
distance of greater than 20 cm between the antenna and all persons during normal use.
© Scope Communications UK Ltd, 2014 All Rights Reserved
********************************************************************************
DLINKMK3ACUSA Issue 1
3