Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for scope Digilink MK3
Summary of Contents for scope Digilink MK3
- Page 1 Digilink MK3 10/5 Zone Telemetry Transmitter, USA Mains Version Installation & User Manual Scope Communications UK Ltd, Quantum House, Steamer Quay Rd, Totnes, Devon TQ9 5AL Tel: +44 (0)1803 860700 Fax: +44 (0)1803 863716 Email: sales@scope-uk.com Web: www.scope-uk.com DLINKMK3ACUSA Issue 1...
- Page 2 Important Installation Information It is the purchasers’ responsibility to determine the suitability of this equipment and its derivatives for any given application, Scope cannot give specific advice in this manual, as each use will require independent evaluation. Scope has, wherever possible, employed extra safeguards to monitor the system’s performance.
- Page 3 1 meter of the equipment. Liability Scope does not accept liability for any damage or injury, howsoever caused as the result of misuse of this equipment. It is the responsibility of the user to ensure that the equipment is operated in the...
-
Page 4: System Overview
Digilink MK3, USA Mains Version System Overview The Scope Digilink MK3 DL10AC and DL5AC are mains powered, programmable radio paging systems which can be used to transmit data to fixed base stations and/or portable receivers. The unit is supplied with either 5 or 10 inputs, which can be hardware configured to accept either dry contact (no voltage) or voltage (5-18V dc) triggers. - Page 5 Digilink MK3, USA Mains Version Note ! the Digilink transmitter is only permitted for use with the Scope antennas listed below, all of which are zero Db gain. Use of other antennas may invalidate any or all approvals pertaining to this equipment.
- Page 6 If configured for voltage input (5-18V dc), the jumper link beside the relevant terminal must be positioned nearest the “V” symbol marked on the circuit board (see Diagram 2). If in doubt, check with Scope before proceeding; incorrect connection may cause permanent damage.
- Page 7 Digilink MK3, USA Mains Version Installation WARNING ! Isolate mains supply before removing cover. The circuit boards contain static sensitive components. Care should be taken to avoid contact wherever possible and anti-static precautions should be observed during installation. Dia gram 1...
- Page 8 Digilink MK3, USA Mains Version DLINKMK3ACUSA Issue 1...
-
Page 9: Section 2: System Operation
Digilink MK3, USA Mains Version Section 2: System Operation Confirmation of power connection is by way of the red PWR indicator on the base of the chassis. Confirmation of transmit is by way of the momentary green TX indicator on the base of the chassis. -
Page 10: Other Antennas
Pre-terminated coaxial feeder cables are available for 5, 10 or 15 metre requirements. Consult your dealer for further details. Note ! Only permitted for use with the above Scope approved antennas, all of which are zero Db gain. High frequencies can equate to high power losses. Always use quality cable. RG58 is only acceptable on cable runs of up to 5 metres. -
Page 11: System Specification
Relay output for Power Fail indication USB port for programming function only Footprint (mm): 328 (L) x 190 (W) x 75 (D) max excluding aerial Scope’s policy is one of continuous development and specifications are subject to change without prior notice DLINKMK3ACUSA Issue 1...