Troubleshooting - Bellman & Symfon Alarm clock Pro User Manual

Alarm clock Pro
Settings
Flash and sound on/off
Press the flash and sound on/off button marked with
the options. A symbol will appear on the clock face when the flash is turned off and a
muted.
Display backlight
Press the button marked with
Time format
Press the time format button marked with 12/24h on the back of the alarm clock to toggle between a 24h and a 12h setting.
Alarm clock accessories
The alarm clock can be complemented with the following accessories:
BE9105 Telephone cord

Use it to connect the landline telephone to the alarm clock
RJ11 input and be alerted when the telephone rings.
BE9250 Mobile phone sensor

Connect it to the ext. trig. input and place it on the
display to be alerted by incoming calls or messages.
BE9024 Contact mat

Connect it to the ext. trig. input to be alerted when
your spouse leaves the bed.

Troubleshooting

If
The alarm clock seems to be turned off
The symbol on the clock face
starts to blink
A symbol appears on the clock face
A symbol appears on the clock face
A symbol appears on the clock face
The display is too bright or too dark or
I want it to be permanently lit
The bed shaker does not vibrate
The alarm volume is too low
on the back of the alarm clock repeatedly to toggle between
repeatedly to adjust the intensity in 4 steps. Step 5 results in permanent backlight.
Try this
Check that the power supply is connected correctly, see Getting started.

Charge the backup batteries for a couple of hours.

The power supply is disconnected and the backup batteries are nearly depleted.

Connect the power supply and charge the backup batteries for a couple of hours.
The alarm clock detects no backup batteries. Pull the battery tab, see Getting

started. If the problem remains, check the backup batteries.
The flash is turned off. Press the flash and sound on/off button marked with

until the symbol disappears if you wish to turn it back on.
The sound is muted. Press the flash and sound on/off button marked with

until the symbol disappears if you wish to turn it back on.
Press the button marked with

Choose step 5 that results in permanent backlight.

Make sure it's connected properly to the alarm clock, see Getting started.

The volume increases gradually and reaches over 100 dB.

symbol when the sound is
repeatedly to adjust the intensity in 4 steps.