Table of Contents
Advertisement
1.6
FINISHING
Figure 11 shows the minimum vertical and correspond-
ing maximum horizontal dimensions of mantels or other
combustible projections above the gas heater.
1.7
LOG INSTALLATION
Carefully remove the log package from the fireplace
and the logs from their package. Handle logs gently.
Place the logs in the fireplace by following the steps
shown in Figure 10.
Replace the glass door and trim door previously re-
moved prior to lighting the unit. Be certain the gas
logs are properly positioned.
FIGURE 11
1.8
INSTALLER TESTING
The space heater must be tested and be operating ac-
cording to manufacturers specifications prior to the in-
staller leaving the site. Note: the tips of the flames
should never hit the top of the firebox after the unit has
warmed up. Please contact your dealer or a qualified
service person to replace injector or adjust valve.
Upon completing the gas line connection, a small
amount of air will be in the lines. When first lighting the
pilot light, it will take a few minutes for the lines to
purge themselves of this air. Once the purging is com-
plete, the pilot and burner will light and operate as indi-
cated in the Lighting Instructions.
Subsequent lights of the appliance will not require such
purging.
CAUTION:
DURING THE INITIAL PURGING AND
SUBSEQUENT LIGHTING'S, NEVER ALLOW THE
GAS VALVE CONTROL KNOB TO REMAIN DE-
PRESSED IN THE "PILOT" POSITION WITHOUT
PUSHING THE RED IGNITOR BUTTON AT LEAST
ONCE EVERY SECOND.
Follow the Safety Information and Lighting Instructions
pages of this manual to light the appliance.
To obtain proper operation, it is imperative that the pi-
lot and main burner flame characteristics are steady,
not lifting or floating. Typically, the 3/8-inch (10mm) at
the pilot generator should be engulfed in the pilot flame.
(Figure 12).
Burner flame patterns are shown in Figure 13.
Proper gas log positioning is shown in Figure 10.
Follow Section 1.6 TROUBLESHOOTING for adjusting
the appliance to operate properly.
11
Hide quick links:
Advertisement
Table of Contents
