Table of Contents
Advertisement
1.4
FAN
Model ATS-AUST has a factory installed Fan, Junction
Box, variable speed Rheostat Control Switch, and Tem-
perature Sensor Switch for the fan. The fan, tempera-
ture sensor switch, and junction box are located be-
hind the lower grille. To provide the 240 VAC needed at
the Junction Box, simply plug the 3-prong grounded
cord into a 3-prong grounded 240 VAC wall outlet. This
cord exits the unit at the lower right hand corner.
1.5
INSTALLING THE SURROUND
NOTE:
REMOVE FRONT TRIM DOOR AND GLASS
DOOR ASSEMBLIES FROM THE INSERT BEFORE
SURROUND INSTALLATION.
1. Find the coiled low voltage wires and ON/OFF switch
attached to outer right side of the insert. See Figure 9.
2. Disconnect the ON/OFF switch from the low voltage
wire leads, and insert the short wires of the ON/OFF
switch through the hole at the upper right corner of
the surround and push the back of the switch through
the hole - it will be retained in the hole.
3. Run the low voltage lead wires up the back of the
right side of the surround and secure them with the
three wire ties found there. Reconnect the low volt-
age wires to the short wires of the ON/OFF switch.
4. Remove and retain the four surround attachment
screws at the corners of the face of the unit. See
Figure 9.
5. Slide the surround against the face of the unit, align-
ing the holes in upper and lower, right and left cor-
ners and secure the surround to the unit with the
attachment screws.
NOTE: PLACE THE THREE INSULATION PIECES
INTO THE CAVITIES AT THE BACK OF THE SUR-
ROUND BEFORE POSITIONING THE INSERT INTO
THE FACTORY-BUILT OR MASONRY FIREPLACE.
THIS INSULATION WILL HELP SEAL FOR COLD
AIR LEAKS.
9
Hide quick links:
Advertisement
Table of Contents
