Panel Installation - Sub-Zero Designer Series Installation Manual

Door Panel
Custom Panel
TOE KICK CLEARANCE
The height of the toe kick area can extend beyond the
typical toe kick height, provided it does not exceed the
dimensions in the illustration below.
876 mm
TYPICAL
PRODUCT
HEIGHT
587 mm
TO BACK OF UNIT
DOOR
PANEL HINGE
DECORATIVE KICKPLATE
CANNOT EXTEND
BEYOND THIS
POINT
51 mm
86 mm*
TO
29 mm
114 mm
DECORATIVE
KICKPLATE
FROM KICKPLATE
ADJUSTMENT
FLOOR HEIGHT
89 mm
MAX DEPTH
*Not included. Dimension will vary as the product height increases or decreases
from the typical product height.
Toe kick clearance (side view)
6 | English
MAXIMUM DOOR OPENING
As the panel width and/or depth increases, so does the
potential for panel interference. Interference may be
minimized by using the 90° door stop.
DOOR OPEN
MAXIMUM 115°
DOOR
OPEN
90°
10 mm
DOOR CLOSED
3 mm
REVEAL
19 mm
PANEL
ADJACENT
CABINETRY
Maximum door opening (top view)
Installation

Panel Installation

DOOR PANEL INSTALLATION
Typical panel dimensions are based on an 876 mm finished
height with 3 mm reveals. Placement of the template must
be adjusted for panels exceeding the typical dimensions.
Place the panel face down on a protected work surface.
Position the template flush with the top and sides of the
panel. Verify the correct side of the template is being used,
then mark and drill holes. Refer to the illustration below.
Use a Torx drive to partially insert a #8 x 1/2" screw into the
second hole from the top on each side of the panel. The
screws should be approximately 4 mm proud of the panel
and will support the weight of the panel during installation.
Align the support screws on the back of the panel with the
slotted holes on both door mounting brackets. Refer to
the illustration below. Opening the door slightly may help
with alignment. Once the panel is supported by the screws,
partially insert a #8 x 1/2" screw into the second hole from
the bottom on each side of the panel, but do not tighten.
CAUTION
As reveals between cabinetry and the unit decrease,
severe finger pinching can occur while the door is
closing.
TOP OF DOOR PANEL
BACK OF PANEL
TOP OF DOOR PANEL
Door panel template Door panel mounting
DOOR PANEL ADJUSTMENT
Close the door. Make any necessary adjustments to align
the panel and reveals.
For side-to-side adjustment, move the panel side to side,
then install and tighten all mounting screws.
For up-and-down and in-and-out adjustments, slightly
loosen the bracket screws. Depending on the level of
adjustment required, it may be helpful to loosen all of the
bracket screws which will allow for maximum adjustment.
Once the bracket screws are loosened, use a wrench to
rotate the cams to make adjustments. After the adjust-
ments have been made, tighten all bracket screws. Refer to
the illustrations below.
IN-AND-OUT
CAM
BRACKET
BRACKET
SCREWS
SCREWS
UP-AND-DOWN
CAM
In-and-out adjustment Up-and-down adjustment