Table of Contents
Advertisement
General Information and Instructions
Always visually inspect your grill before lighting. Replace any hoses that are frayed or cracked before
lighting your grill. Look for anything that may be blocking spaces for ventilation and remove. After
lighting, always check the flame to ensure you have a good flame all along each burner. If not able to
light, or the flame is not even along the entire burner(s), then see the Trouble Shooting section.
1. Read instructions before lighting.
2. If ignition does not occur in 5 seconds, turn the burner control(s) off, wait 5 minutes
and repeat the lighting procedure.
LIGHTING THE MAIN BURNERS USING ELECTRONIC IGNITION
1. Ensure all burner control knobs are in the "Off" position.
2. Turn on the LP gas by turning the hand wheel on the cylinder valve.
3. Turn one burner control knob marked with an igniter flame "" to "High".
4. Depress the electronic ignition button and hold down. You should hear a clicking sound, which
shows the electronic ignition is working.
5. If the burner does not light within 5 seconds, turn the burner control knob to "Off". Wait 5 minutes
for the gas to clear, and repeat the above procedure. Use the Manual directions if it still will not light.
6. When lit, turn the control knob to the desired setting.
MANUALLY LIGHTING THE BURNERS WITH THE MATCH LIGHTING STICK
1. Ensure all burners are in the "Off" position.
2. Slowly turn on the gas at the LP tank valve if it is not already on.
3. Place a match in the Match Holder. This is located in the top center drawer of the grill cabinet
underneath the right main burner.
4. Use the holder to slide the lit match though the cooking grates and the front of the heat tent to the
left of the burner you wish to light.
5. Press and turn the burner control knob to "HI/LIGHT". Continue to push in and hold up to 5 seconds
or until the burner lights.
6. If the burner does not light within 5 seconds, turn the burner control knob to "Off". Wait 5 minutes
for gas to clear, and try again.
7. When lit, turn the control knob to the desired heat setting.
TURNING OFF YOUR GRILL
1. Turn off the gas supply at the LP tank by turning the valve clockwise.
2. Turn all burner control knobs to the "Off" position.
10
LIGHTING
WARNING:
Advertisement
Table of Contents
