Belt Clip; Charging Battery - Radioddity GS-5B User Manual

Visit Radioddity.com For Downloads And Help 03

Belt clip

There are two screws mounted on the rear of the radio
body where the belt clip attaches. Remove the two screws
and align the belt clip with the holes where you removed
the screws. Place the screws you removed into the belt
clip and tighten them into the radio body.
Do not add any form of glue or thread lock to the screws on
the battery clip.
The solvents in the glue may cause damage to the radio or
battery casing.
Installing & Removing Battery
1. Match the two top grooves of the battery pack on the back of the radio and
then push it.
2. Screw it clockwise to install the battery.
3. Unscrew counter-clock-wise to remove the battery.
1 2
1 2
3 4
4
3
Visit Radioddity.com For Downloads And Help 04
Installing & Removing Antenna
Screw the antenna into the connector on the top of the
transceiver by holding the antenna at its base and turning
it clockwise until secure.
Note: Turn the antenna counter-clockwise until you can
remove it.

Charging Battery

Use only the charger and battery specified by the manufacturer. The charger
LED indicates the charging progress.
1
1. As 1 shown, Plug the AC adaptor into the AC outlet, and then plug the
cable of the AC adaptor into the DC jack located on the back of the charger.
2. As shown, Plug the radio into the charger. Make sure the battery
2
terminals are good in contact with charging terminals.
3. The indicator light turns to red, the charging begins.
4. The indicator light turns to green, the charging is completed.
2