Charging The Batteries - Quickie WheelDrive User Manual

14

4.2 Charging the batteries

Only use the supplied battery chargers to
charge the battery packs (fi gure 4). The battery
pack include electronics to control the charging
process – it will disconnect the charger in case
the batteries are fully charged; overloading is
not possible.
Each wheel has a separate battery. Both
battery packs need to be charged separately.
Both chargers can be used for both battery
packs. Batteries can be charged when they are
mounted on the power assist. Batteries can
also be taken off for charging.
To prevent you from getting into a situation
where no power assistance is available, it is
strongly recommended to charge both batteries
every day.
Each battery pack has a charge connector with
a black cover. Open the cover and insert the
plug with the fl at side to the left (fi gure 5).
In case the power assist is switched ON, the
charging level of the main battery is indicated
via the battery indication LEDs on the user
interface (fi gure 6).
Warning!
In case all battery indication LEDs are off
when the power assist is turned on, this
might be due to a system error. Please
contact your dealer.
During charging the LED on the charger will
turn red.
When the battery is fully charged, the LED
indicator of the charger will turn green. Now you
can disconnect the plug. Please pull at the plug
itself, not the cord.
After disconnecting the plug, close the black
connector cover to prevent water and dirt
coming in.
The charger plug is not properly connected
when the red light on the charger fl ashes.
Unplug the battery and reinsert it. If the light
keeps fl ashing please contact your dealer.
Filled is on
Battery indication White is off
80% - 100% full
5 LEDs on
60% - 80% full
4 LEDs on
40% - 60% full
3 LEDs on
20% - 40% full
2 LEDs on
10% - 20% full
1 LED blinking slowly
Almost empty
Less than 10%
Auto power off
1 LED blinking quickly
forthcoming
WheelDrive
4
5
6
Beeping 5 times
Beeping 5 times