Quickie WheelDrive User Manual page 15

Power assist
Table of Contents

Advertisement

WheelDrive
During charging, the LEDs that are not ON,
indicate the charge status by lighting the
remaining LED's stepwise as shown in fi gure 7.
Caution!
Never subject the charger to humidity – only
use it indoors.
Never charge the battery packs at
temperatures below 0°C or above 30°C.
Do not store batteries at high temperatures
(this will reduce the service life signifi cantly).
Charge the battery pack completely before
long-term storage, and check the charge
level every 3 months. Even not-used
batteries will discharge slowly; prevent the
batteries to become completely empty (deep
discharge of the batteries will damage the
batteries).
Never pull the cable to remove the battery
charger from the mains or charge connector.
Always attach the black connector cover if
no battery charger is connected, to prevent
water and dirt coming in.
Warning!
In case the batteries are completely empty
the power assist will shut down automatically
to prevent deep-discharge (and damaging) of
the batteries. The wheels continue to run, but
power assistance is not available anymore.
During charging the batteries of the power
assist, no power assistance is available.
Do not drive with the power assist during
charging the batteries if they are attached to
the wheels.
Check your battery level before starting a
ride.
Step 1
Step 2
Step 3
Step 4
Step 5
Step 1
Etc.
15
7

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents