Quickie WheelDrive User Manual page 31

WheelDrive
During normal usage, the following signalling can occur
Signal
Long beeps for
several seconds
Battery indication
off for approx.
4 seconds then
blinking and beeping
for approx 7 seconds
Long beeps
3 beeps,
repeating until
rotation stops
If the issue cannot be solved, please contact
your dealer.
Eff ect Notifi cation
Braking on the Speed is getting too
motor activated high
The power assist Loss of contact with
will switch to battery management
less accurate system
method of
battery capacity
measurement
Power will be Power assist not used
switched off for 15 minutes
Wheel handle not
closed
Battery is empty
Speed is too high
OFF button is pushed
Possibly damage Wheel is rotating
to charger cable while charger is
or connector connected
Solution
Slow down to 2 km/h
Replace battery pack
Turn on the system if you want
to use the power assist again
Close the wheel handle and
put on the system if you want
to use the power assist again
Recharge your batteries and
put on the system if you want
to use the power assist again
Slow down the wheelchair
to a standstill and put on the
system if you want to use the
power assist again
Put on the system if you want
to use the power assist again
Stop rotating the wheel
31