Quickie WheelDrive User Manual page 9

Power assist
Table of Contents

Advertisement

WheelDrive
Only use the power assist in situations you
would normally use a manual wheelchair as
well. With the power switched off , the power
assist behaves just like a manual wheelchair.
In order to have enough battery capacity it
is adviced to charge the batteries, when the
power assist is not being used.
It is advised to mount a smoke detector in
the charging area.
Disconnect batteries in case of longer
storage without usage.
When not using the power assist always
engage the parking brake of your wheelchair.
Do not use the power assist in combination
with a wheelchair puller or hand bike. The
power assist is not designed for the speeds
of these applications.
It is advised never to use the power assist
on a slope with an angle of more than 6°,
above this angle the power assist can be
insuffi cient.
While driving on a slope and taking obstacles
only use the large rim. In case of emergency
you can propel and brake manually
Caution!
Never open the batteries or electronic
housings.
Do not connect any other equipment to the
power assist.
Do not drive faster than 6 km/h with the
power assist without connected batteries to
prevent potential damage to the system.
Driving through deep puddles is not
considered as normal use and may cause
damage to the motors and other electronics.
Never clean the power assist using a hose or
pressure washer.
It is best to charge the batteries daily.
The power assist should be cleaned with a
damp cloth only.
In case of possible technical malfunctioning,
please contact your dealer.
9

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents