Advertisement
Confer 6000_9_04
9/23/04
2:13 PM
Page 3
CONFER PLASTICS, INC.
Model 6000 Adjustable Heavy-Duty Inpool Ladder
PARTS LIST
HARDWARE PACK
2 - Handrail
26-#10 x 1-1/4" S/S Screw
2 - Stringer (Leg)
4 - Upper tread
1 - Bottom tread
1 - Platform
2 - Mounting block
2 - Adjustable tube
Step 1.
Snap stringers
into bottom tread.
Tread Lugs
If necessary lift
the two stringers
off the ground,
with the bottom
tread attached,
and drop them
firmly so that the
stringers "snap"
into the tread
Make sure the
pockets. The
single row of
bottom tread
tread lugs are
should pivot
facing forward.
freely.
Step 3.
Secure the
upper treads
by driving
#10 x 1-1/4"
screws through
the recessed,
pre-drilled holes
in the ends of
each tread as
shown. Repeat
for all 4 upper
treads.
2
TOOLS REQUIRED FOR ASSEMBLY:
• Cordless Drill Motor
• 1/8" Drill Bit
• Phillips Screwdriver or screwdriver bits
• Pliers
Step 2.
Two sets of Lug
locations are provided.
Attach 4 upper treads
Use upper
to the stringers in the
lugs for
position determined by
50" to 54" pools.
the pool height.
Use lower
lugs for
x4
42" to 48" pools.
Tread Lugs
Step 4.
Using a pair of pliers twist off
the wedges from the end of
the platform and SAVE for
use in step 5.
Wedges
Detach
Wedges
Protrusion
Step 5.
After platform is in
position, tap in the
supplied wedges at
Assemble the platform to
the bottom of each
the handrails by laying
opening to ensure a
one of the handrails on a
secure fit
clean hard surface. Push
the protrusion of the plat-
form into the openings of
the handrail making sure
that the legs of both
Match
Platform
Push
handrails are facing in the
protrusions
down
same direction. Tap the
to Handrail
4 wedges (from step 4)
openings
into the sides of the
handrails to secure the
platform to the rails.
Step 7.
Push the
adjustable tubes
with mounting
blocks into
handrails.
Step 9.
Attach the handrails to
the ladder assembly,
making certain that the
treads face correctly.
Step 6.
x2
Coat the adjustable
tubes with a lubricant,
such as liquid dish
detergent, and slip the
mounting blocks all
the way down over the
protruding nubs.
Mounting Block
Slide mounting
Adjustable tube
blocks over nubs
Step 8.
Fill both stringers with water to
allow the ladder to be submerged
in the pool.
Stringers
Step 10.
Submerge in
water and tilt to a
15° angle to allow
water to fill the
treads.
3
Advertisement
