Machine Card And Logbook - Toshiba MMY-MAP0806HT8P-E Installation Manual

Check code
Indication on 7-segment display on the outdoor unit
Auxiliary code
01: Compressor 1
P07
02: Compressor 2
P10 Detected indoor unit address
P13 —
01: TS condition
P15
02: TD condition
P17 —
P19 Detected outdoor unit number
P20 —
#0: Element short circuit
#E: Vdc voltage error
#1: Position detection circuit error
#2: Input current sensor error
#3: Motor lock error
P22
#C: Sensor temperature error (No TH sensor)
#4: Motor current error
#D: Sensor short circuit/release error (No TH sensor)
#5: Synchronization/step-out error
*Put in Fan IPDU No. in [#] mark.
01: Compressor 1
P26
02: Compressor 2
01: Compressor 1
P29
02: Compressor 2
*IPDU number information
01: Compressor 1 error
02: Compressor 2 error
03: Compressor 1 and 2 error
08: Fan1 error
09: Compressor 1, Fan1 error
0A: Compressor 2, Fan1 error
0B: Compressor 1 and 2, Fan1 error
167-EN
1117101201-3 EN.indd 84 1117101201-3 EN.indd 84
Check code name
Heat sink overheat error
Indoor overflow error
Outdoor unit flow back error detected
Gas leak detection
Discharge temperature TD2 error
4-way valve inverse error
High-pressure protective operation
Outdoor fan IPDU error
G-TR short protection error
Compressor position detecting circuit error
11: Compressor 1, Fan 2 error
12: Compressor 2, Fan 2 error
13: Compressor 1 and 2, Fan2 error
18: Fan 1 and 2 error
19: Compressor 1, Fan1 and 2 error
1A: Compressor 2, Fan1 and 2 error
1B: All
12

Machine card and logbook

Machine card
After test run, fill the items on the machine card and paste the card on an accessible place on the product securely
before delivery to the customer.
Describe the following items on the machine card:
name, address and telephone number of the installer, his service department, the service department of the party
concerned or at any addresses and telephone numbers of fire department, police, hospitals and burn centres;
Logbook
Update the log periodically after maintenance as defined in EN378-4.
Describe the following items on the logbook:
1. details of the maintenance and repair works;
2. quantities, kind of (new, reused, recycled) refrigerant which have been charged on each occasion, the
quantities of refrigerant which have been transferred from the system on each occasion (see also EN378-4);
3. if there is an analysis of a reused refrigerant, the results shall be kept in the logbook;
4. source of the reused refrigerant;
5. changes and replacements of components of the system;
6. result of all periodic routine tests;
7. significant periods of non-use.
– 84 –
168-EN
8/8/2559 BE 3:49 PM 8/8/2559 BE 3:49 PM