Precautions For Safety - Toshiba MMY-MAP0806HT8P-E Installation Manual

1

Precautions for safety

The manufacturer shall not assume any liability for the damage
caused by not observing the description of this manual.
WARNING
General
• Before starting to install the air conditioner, read through the
Installation Manual carefully, and follow its instructions to install
the air conditioner. Otherwise, falling down of the unit may occur,
or the unit may cause noise, vibration or water leakage.
• Only a qualified installer(*1) or qualified service person(*1) is
allowed to do installation work. If installation is carried out by
an unqualified individual, a fire, electric shocks, injury, water
leakage, noise and/or vibration may result.
• If using separately sold products, make sure to use Toshiba
specified products only. Using unspecified products may cause
fire, electric shock, water leak or other failure.
• Do not use any refrigerant different from the one specified for
complement or replacement.
Otherwise, abnormally high pressure may be generated in the
refrigeration cycle, which may result in a failure or explosion of
the product or an injury to your body.
• Before opening the service panel of the outdoor unit, set the
circuit breaker to the OFF position. Failure to set the circuit
breaker to the OFF position may result in electric shocks through
contact with the interior parts. Only a qualified installer(*1) or
qualified service person(*1) is allowed to remove the service
panel of the outdoor unit and do the work required.
• Before carrying out the installation, maintenance, repair or
removal work, be sure to set the circuit breakers for both the
indoor and outdoor units to the OFF position. Otherwise, electric
shock may result.
5-EN
1117101201-3 EN.indd 3 1117101201-3 EN.indd 3
– 3 –
• Place a "Work in progress" sign near the circuit breaker while the
installation, maintenance, repair or removal work is being carried
out. There is a danger of electric shocks if the circuit breaker is
set to ON by mistake.
• Only a qualified installer(*1) or qualified service person(*1) is
allowed to undertake work at heights using a stand of 50 cm or
more or to remove the intake grille of the indoor unit to undertake
work.
• Wear protective gloves and safety work clothing during
installation, servicing and removal.
• Do not touch the aluminium fin of the outdoor unit. You may
injure yourself if you do so. If the fin must be touched for some
reason, first put on protective gloves and safety work clothing,
and then proceed.
• Do not climb onto or place objects on top of the outdoor unit. You
may fall or the objects may fall off of the outdoor unit and result
in injury.
• When working at height, put a sign in place so that no-one will
approach the work location before proceeding with the work.
Parts or other objects may fall from above, possibly injuring a
person below. Also, be sure that workers put on helmets.
• When cleaning the filter or other parts of the outdoor unit, set
the circuit breaker to OFF without fail, and place a "Work in
progress" sign near the circuit breaker before proceeding with
the work.
• The refrigerant used by this air conditioner is the R410A.
• You shall ensure that the air conditioner is transported in stable
condition. If you find any part of the product broken, contact your
dealer.
• Do not disassemble, modify or move the product yourself. Doing
so may cause fire, electric shock, injury or water leaks.
• This appliance is intended to be used by expert or trained users
in shops, in light industry, or for commercial use by lay persons.
6-EN
8/8/2559 BE 3:49 PM 8/8/2559 BE 3:49 PM