How to Replace or Install Cylinder
1. Remove cylinder:
A. Remove outside escutcheon from door.
B. Remove rubber gasket.
C. Insert small flathead screw driver under spring;
(gently) lift spring.
D. Note: notch on top of cylinder engages
spring
E. Remove cylinder by pulling (outward) towards
outside of door.
Before installing cylinder, please be sure tailpiece
is correct length (see below).
2. Install new cylinder:
A. Reverse previous steps for removing cylinder.
C
Cylinder tailpiece information:
Requires addition of Thin Door Kit.
*
An ASSA ABLOY Group brand
L
1-3/8"* to 2" thick doors, L = 3-1/2" (88.8mm)
2" to 2-1/4" thick doors, L = 3-3/4" (95.3mm)
A
D
E
Tailpiece
T = .098" (2.5mm)
W = .2" (5.2mm)
w
T
B
17
P/N AYRD220-INST-FUL Rev B