Yale Real Living YRD210-ZB Installation And Programming Instructions page 9

5. Secure both assemblies using (2) M6 x 59.5mm pan
head machine screws, making sure that outside
escutcheon is vertically aligned.
Tighten securely with a #2 Phillips screwdriver.
Do not over-tighten.
6. Attach cable assembly to the inside escutcheon
printed circuit board (PCB) by lining up notches on
top of cable connector to slots on PCB connector
(Fig. 6B). Press connector in firmly using thumbs
until completely seated (proper position indicated
by arrows on PCB as in Figures 6A and 6B).
CAUTION:
Use care when assembling to ensure that
the cable lies against the back recessed
area of the inside escutcheon (Fig. 6A).
Position and bend cable, using the harness
clip as shown in Fig. 6A to prevent binding
when installing the escutcheon over the
mounting plate.
7. Install inside escutcheon on inside mounting plate.
Note in Fig. 7A the horizontal orientation of the tail
piece as you insert the inside escutcheon (thumb
turn should be vertical).
NOTE: The bolt must be in a retracted (unlocked) position
prior to installing the batteries.
8. Install and secure using (3) M4 x 8mm [8-32 x 5/16"]
pan head screws through the inside escutcheon into
the mounting plate.
IMPORTANT: Before installing the batteries, test
the mechanical operation of the lock by using
both thumb turn and the key. The movement of the
bolt should be smooth and unobstructed. If
operation is not smooth, review the previous steps
to ensure proper installation.
9. Insert four (4) AA alkaline batteries. The lock responds,
"Welcome to Yale Real Living™". When activating
the lock for the first time, the lock will adjust for
proper handing.
Note: Refer to programming instructions prior to
completion of step 10.
10. Install battery cover and tighten Phillips head screw.
An ASSA ABLOY Group brand
Figure 6B
Route cable
as indicated -
do not cover
Harness
clip
Figure 6A
Figure 7A
P/N AYRD220-INST-FUL Rev B
hole
8