Cleaning & Protecting - Sea Eagle RIB11 Instruction & Owner's Manual

RIB11 | ASSEMBLY & INFLATION
Fully assembled and ready to go.
Deluxe
Swivel Seat
Honda Motor
RIB11 | DEFLATION
RIB11 | CLEANING & PROTECTING
Dry after each use to avoid mold. While washing or
rinsing: close the air valves and twist the cap on so water
cannot not enter the chamber. Sea Eagles can be cleaned
very effectively with general purpose cleaning products and a
scrub brush. Towel dry.
Fiberglass: Clean and wax fiberglass surfaces to keep looking
shiny and new. Many types of cleaners are available. Do not
wax non-skid deck surface. Bottom of fiberglass hull can be
painted with bottom paint. Inflatable portion can be coated
with inflatable antifouling paint.
Protection from the Sun and Heat
Avoid leaving the boat in direct sunlight when ashore.
Temperatures on a beach, dock, davit, etc. can get very high,
which could affect the vinyl or glue. Excessive exposure to sun
and heat can cause your Sea Eagle to become sticky or cause
the glue to fail.
Treat the boat with a UV protectant such as 303 Aerospace
Protectant. Generally, protectants are a thin film of oil, which
will help keep your Sea Eagle clean. Avoid applying protectant
on the EVA pad or places where foot traction is needed.
Treated boat will repel sand, water scum and tar stains.
RIB11 | STORAGE
If you're planning to leave your Sea Eagle outside, keep it raised
off the ground and covered so it is not exposed to sunlight,
rain, leaves, berries, bird droppings, etc.
• Rodent-proof the storage area. Mice, squirrels and other small
rodents can do a lot of damage.
• Avoid excess heat. Do not store in direct sunlight, in an attic or
a metal shed.
• In temperatures below freezing, do not drop or strike until the
boat is brought to room temperature.
• It can be stored inflated. If hung, support by lifting rings.
• After storage, inspect for loose items, damage and leaks.
To deflate, push down on
the valve stem and
quarter turn it to the right.
The stem will stay in the
down position, allowing
the air to escape.
Caution: Air escapes
with force, do not place
face directly over valve.
9