Auto Power Mode - Buffalo TeraStation Setup Manual

Auto Power Mode

The TeraStation can be configured to automatically turn on and off with your computer. To use this feature, install NAS
Navigator 2 on your computer(s) and then set the power mode switch on the back of your TeraStation to "Auto".
<TS-XL Series> <TS-XEL Series>
<TS-WXL/R1, TS-WXL/1D
Series>
Notes:
• After you turn off your computer, it may take several minutes for the TeraStation to shut down.
• When the power mode switch is changed from Auto to Manual or vice-versa, it takes about five minutes
for the change to take effect.
• Power on the TeraStation before moving the switch to the Auto position.
• Auto Power Mode doesn't work if port trunking is enabled or if NasNavi detection is disabled.
• Install NAS Navigator 2 on all computers that will be accessing the TeraStation before switching to Auto
Power Mode.
• Some networks may not support the Auto Power Mode. If you have problems with it, just use Manual
Power Mode.
TeraStation Setup Manual
Manual (default):
In this position, the power button on the front of the TeraStation turns it
on and off. It is not affected by the power state of connected computers.
Auto:
In this position, if all connected computers are turned off, the TeraStation
will turn off too. If a connected computer is powered on, the TeraStation
will power on too.
<TS-RXL Series>
13