Basic Settings; Changing The Basic Settings - Siemens Teppan Yaki Instruction Manual

QBasic settings
Y our appliance has various basic settings. You can
B a s i c s e t t i n g s
adapt these settings to suit your own needs.
Display Function
Reset the basic settings
™‹
Switched off.*
‹
Switched on.
‚
Childproof lock
™‚
Automatic childproof lock switched off.*
‹
Automatic childproof lock switched on.
‚
ƒ Manual and automatic childproof lock switched off.
Audible signal
™ƒ
Confirmation signal and operation error signal switched
‹
off (main switch signal always remains on).
Only the operation error signal is switched on.
‚
Only the confirmation signal is switched on.
ƒ
Confirmation signal and operation error signal switched
„
on.*
Energy consumption display (Ask your electricity
™„
supply company what the mains voltage is.)
Consumption display switched off.*
‹
Consumption display with mains voltage at 230 V.
‚
Consumption display with mains voltage at 220 V.
„
Consumption display with mains voltage at 240 V.
...
Automatic switch-off (The higher the level selected,
™†
the longer the period of time until the appliance
switches off.)
Switch off after 2-4 hours.*
‹
Switch off after 1-2 hours.
‚
Switch off after 30-60 minutes.
ƒ
Duration of the timer end signal
™‡
10 seconds.*
‚
30 seconds.
ƒ
1 minute.
„
Activation of the heating elements
™ˆ
When the appliance is switched on, the rear heating zone
‹
is off.
When the appliance is switched on, both heating zones
‚
are on.*
When the appliance is switched on, the last setting before
ƒ
it was switched off is retained.
Demo mode
™‰
Switched off.*
‹
Switched on. Appliance can be operated but does not
‚
heat up.
*Basic setting

Changing the basic settings

The appliance must be switched off.
Switch on the appliance.
1.
Within the next 10 seconds, touch the
2.
approximately 4 seconds until an audible signal
sounds.
and flash alternately and
™ ‚
Touch the symbol as many times as necessary
„
3.
until the required indicator appears.
Set the desired value on the control panel.
4.
Repeat steps 3 and 4 until all the required settings
5.
have been changed.
Touch the symbol for approximately 4 seconds
„
6.
until an audible signal sounds.
The settings have been saved.
Discarding the changes
To exit the basic settings, switch off the appliance with
the main switch. Changes are not saved.

Basic settings

symbol for
„
lights up.
‹
13
en