JPT YDFLP Installation Manual And User's Manual page 18

YDFLP Fiber Laser Installation
Guide and User Manual
It will waste 50ns to finish the fiber laser pulse width initialization.
Remarks: If Instruction code transmit 3 * 0x01 instruction, the fiber laser will refuse to receipt.
3.2.4 Pulse width control clock diagram
Below is the 200ns pulse width sample serial clock diagram, The byte order is below when
used the 0x01 instruction:
0XA5/0X01/0x00/0XC8 0x00 and 0xC8 representative pulse width
Figure 12 Pulse control clock diagram
The parameters of this instruction are the binary values of the pulse width. Users can compile
any values of pulse width, but the laser can only receive the signals of specified pulse width
(please refer to the user manual for specific pulse width). If the value of pulse width is out of the
range of specified pulse width, the laser will choose the default pulse width set last time.
File Number: EFLP001‐B‐E Shenzhen JPT Opto‐electronics Co. Ltd.
Version：B Date:2016.4
18