Advertisement
STEP 3: Slide the cover back to seal the bottom of the
WNAP-7206.
STEP 4: Take out the Power Adapter and PoE injector,
plug the Power Adapter into the DC port and plug
the other side of the RJ-45 cable in the STEP 2
into the POE port of the PoE injector.
To WNAP-7206
1. Assign a static IP address to your PC which should be
in the same network segment with the WNAP-7206. As
the
default
IP
address
192.168.1.1, you may choose from 192.168.1.2 to
192.168.1.254. Then click OK.
2. Open the web browser on your PC, key in the IP
address (192.168.1.1) of the WNAP-7206 in the
address bar, and then enter.
3. The default User name and Password are both
"admin". Enter them and then click OK.
Default IP Address: 192.168.1.1
Default Username: admin
Default Password: admin
Default SSID: default
To LAN Switch or PC
– 5 –
of
the
WNAP-7206
– 7 –
STEP 5: Successful installation.
Note
5. Web Login
Connect the WNAP-7206 with your PC by an Ethernet
cable plugging in LAN port of PoE injector in one side and
in LAN port of PC in the other side. Power on the
WNAP-7206 by PoE from PoE injector.
When you enter into the Web User Interface, click Quick
Setup from the menu bar. Once the basic configuration of
the AP is done. Click Finish button to make the change
is
take effect.
FURTHER INFORMATION:
The
above
configurations for WNAP-7206. For further configurations
of different operation modes, please refer to the user's
manual in the CD. If you have further questions, please
contact the local dealer or distributor where you purchased
this product.
Users MUST use the "Power Adapter & PoE
Injector"
shipped
in
WNAP-7206. Otherwise, the product may be
damaged.
– 6 –
steps
introduce
simple
– 8 –
the
box
with
the
installations
and
2011-E10490-000
Advertisement
