Assembly - Intense Cycles Sniper Trail User Manual

Assembly

P R E F A C E //
Service and maintenance on an Intense bicycle requires special tools, abilities and
knowledge of working on bicycles. It is always recommended to use an authorized
Intense dealer for service and maintenance. Always wear eye protection. It is critical
to use the proper tools, loctite, grease and torque specs during assembly. Failure to
follow these instructions may result in serious bodily injury or death.
Tools needed
• HIGH GRADE WATERPROOF GREASE
• 5MM HEX WRENCH
• 6MM HEX WRENCH
• 8MM HEX WRENCH
pro tips
• BE SURE TO APPLY A THIN COAT OF GREASE TO ALL PIVOT AXLES AND REAR AXLE.
THIS WILL REDUCE THE CHANCES OF CORROSION DUE TO MOISTURE AND PREVENT ANY
POSSIBLE CREAKS.
• AFTER THE FIRST FEW RIDES AND ALL THE COMPONENTS ARE BROKEN IN AND SETTLED
INTO PLACE, GO THROUGH AND RE TORQUE ALL PIVOT AXLES AND FASTENERS. AFTER
THIS FIRST ADJUSTMENT, YOU WILL BE READY TO RIP FOR THE LONG HAUL.
• USE GREASE ON ANY METAL TO CARBON INTERFACE, INCLUDING BB AND HEADSET.
1 0 / / S N I P E R
• TORQUE WRENCH
• 5MM HEX BIT
• 8MM HEX BIT
• 19MM SOCKET
u s e r m a n u a l