Sony VENICE MPC-3610 Operating Instructions Manual page 69

000 69
4. Shooting: Useful Functions
False Color Display
You can display false color in the viewfinder (DVF-
EL200) attached to the unit by pressing the B/False
Color button on the viewfinder.
Display Signal level S-Log3 description
color
Red 93.3% or higher White clipping
Yellow 91.3% to 93.3% Just below white
clipping
Pink 47.8% to 50.8% One stop over mid
gray
Green 38.9% to 42.2% 18% mid gray
Blue 2.6% to 5.5% Just above black
clipping
Purple –2.4% to 2.6% Black clipping
Viewfinder Double Speed Scan
Function
If the project frame rate is 23.98P, 24P, 25P, or
29.97P, the image may become blurred and hard
to see due to low frame frequency when you
shoot while swaying the unit to the right and the
left.
In this case, you can decrease image blur and
make it easier to see by activating the viewfinder
double speed scan function.
To activate the function, set Monitoring category >
Moni. Details > VF Function > Double Speed Scan
(page 54) in the menu to On.
[Notes]
ˎ When this function is activated, the shutter angle of the ˎ
electronic shutter function is limited to 180 degrees or
lower.
ˎ This function is set to Off during variable speed shooting. ˎ
ˎ This function is enabled for the following combinations of ˎ
image size and project frame rate.
3.8K 16:9 (23.98p, 24p, 25p, 29.97p)
4K 17:9 (23.98p, 24p, 25p, 29.97p)
3.8K 16:9 Surround (23.98p, 24p)
4K 17:9 Surround (23.98p, 24p)
4K 4:3 (23.98p, 24p)
User 3D LUT
You can load a CUBE file (*.cube) for a 17-point
or 33-point 3D LUT created using RAW Viewer
or DaVinci Resolve (by Blackmagic Design)
(page 33).
Set Input Color Space to match the input color
space of when the CUBE file was created.
If the file was created using S-Gamut3.Cine/S-Log3, set
Project category > Basic Setting > Input Color Space
(page 50) in the menu to S-Gamut3.Cine/S-Log3.
Save the User 3D LUT file in the following directory
on the SD card.
PRIVATE\SONY\PRO\LUT\