Table of Contents
Advertisement
WEP Encryption Without Authentication
1. On the
Main Window
(see page 8-3), tap the port and select Configure on the popup menu.
2. On the
Wireless Networks Tab
3. On the
Profile Info Tab
(see page 8-13), select Do active scan.
4. On the
WEP Mgmt Tab
5. Enter the WEP Key; see
6. On the main window, tap Client > Restart to restart the Client.
7. Wait as the Client connects.
8. When the connection is complete, the
Authenticated. However, the log file (see
this event.
Associating With Open APs
To associate with open APs means to set up the 802.11g radio without authentication or encryption.
1. Double-tap the Client icon on the command bar
2. On the
Main Window
(see page 8-3), tap on the port and select Configure on the popup menu.
3. On the
Wireless Networks Tab
4. On the
Profile Info Tab
(see page 8-13), enter your AP's SSID in the Network Profile field.
5. Select default in the Authentication profile drop-down list.
6. On the
WEP Mgmt Tab
7. Tap OK on the Wireless Networks tab.
8. On the
Main Window
(see page 8-3), tap Client > Restart to restart the client.
9. Wait as the Client connects.
10. When connection is complete, the
"Associated".
Note: If your AP is strictly an AP and not a DHCP server, then you must statically assign an IP address and subnet mask.
Dolphin® 7850 Series User's Guide–
Preliminary
(see page 8-10), select the SSID and tap Properties.
(see page 8-15), select Use key for data encryption.
Key
on page
8-15.
Tap OK.
Port Status Icon
Logging
(see page 8-10), tap Add in the Configured Networks section.
(see page 8-15), make sure none of the options are selected.
Port Status Icon
(see page 8-3) on the main window reads Associated instead of
on page 8-9) will read "Entered AUTHENTICATED state" when recording
.
(see page 8-3) turns yellow and the
Rev (b)
5/15/2007
Status Bar
(see page 8-5) reads
8 - 17
Advertisement
Table of Contents
