Back Panel - HandHeld Dolphin 7850 Series User Manual

Back Panel

Handle Saddle
DC Power RS-232 Port
Jack
Auxiliary Battery Well
The auxiliary battery well charges an additional Li-ion battery pack independently of the terminal well. This feature
ensures that you can always have a fully-charged battery for your terminal; see
page 10-3.
DC Power Jack
Connect the power cable to this power jack; see
Handle Saddle
The curve on the back wall of the terminal well accommodates the pistol-grip handle when the terminal is seated in
the well.
RS-232 Port
For RS-232 data communication, use the 9-pin, RS-232 cable from Hand Held Products to connect this port to a
peripheral device. For more information, see
USB Port
This USB Port is full-speed, 2.0 compliant, and requires ActiveSync 4.1 or higher. Using a USB cable, you can
connect the HomeBase to a USB-compliant device. When the HomeBase is connected to that device, the terminal
is connected to the device when seated in the terminal well. The HomeBase acts as a USB device by interfacing
the USB signals of the terminal to the USB signals of the host workstation; see
10-7.
Charging a Spare Battery Pack
The auxiliary battery well located on the back panel
LED (page 10-2) on the front panel indicates the charge status of the battery in this well. Charge time is less than four hours and
the charge process is independent of the terminal well.
1. Insert the end of the battery without the locking tab into the bottom of the auxiliary well opening.
2. Snap the battery into place with a hinging motion. The Aux Battery LED lights orange.
3. The AUX Battery LED monitors the charge progress.
Dolphin® 7850 Series User's Guide–
Preliminary
Auxiliary
Battery
Well
USB Port
Powering the HomeBase
RS-232 Serial Connector
(Auxiliary Battery Well, page 10-3) charges a spare battery. The
Rev (b)
5/15/2007
Charging a Spare Battery Pack
on page 10-5.
on page 10-5.
ActiveSync Communication
on
on page
AUX Battery
10 - 3