Applying Power; Using Ac Power; Using Dc Power - AJA Ki Pro Installation And Operation Manual

24

Applying Power

The installation and set up of a Ki Pro is straight-forward. If you'll be controlling the
unit from the front panel buttons and display, it's ready right out of the box. Just
cable the system's audio and video sources, VTR(s), monitors, and audio equipment,
mount the Ki Pro unit as desired, and begin recording. However, if you wish to control
Ki Pro from a web browser or 802.11 device (iPhone etc.), then there are additional
configuration steps necessary.

Using AC Power

To begin using Ki Pro, plug the 4-pin XLR on the supplied AC adapter into the XLR
power socket on the back of Ki Pro. Then plug the AC adapters line cord into 110 VAC
or 220 VAC (the supply is autosensing).
Warning:
Do not open the chassis. There are no user-serviceable parts inside.
Hazardous voltage is present inside the unit, presenting a risk of electric shock or
serious personal injury. Opening the chassis will void the warranty unless performed
by an AJA service center or licensed facility. Remove the supplied AC line cord from
mains power when moving the unit. Do not defeat the safety purpose of the
grounding-type plug.

Using DC Power

1. Locate Line Cord 2. Insert into DC supply 3. Insert 4-pin XLR into
12Vdc Ki Pro power socket