Controls And Displays - AJA Ki Pro Installation And Operation Manual

10
Operator Side—Buttons and Display
Storage Module
Release
Button
(press and hold button down
while removing Disk Storage
Cartridge)
VU
Meters
(2 Channel)
Audio
Input
Level
Adjust
140 x 16 pixel
Alphanumeric
and Graphics Display
(typically 2 x 20 characters)
Controls and
Displays
Storage Module (slides into slot)
STATUS
CLIP xxxxxxxx
REEL xxx
CONFIG
MEDIA
Transport Control Buttons
(Reverse/Stop/Play/Record/Fast Forward)
Ki Pro Operator Side (front panel)
The Operator Side of Ki Pro features a variety of buttons, knobs, jacks, and
indicators for operating Ki Pro directly. Each of the items found on the "Operator
Side" are described here and on the following pages. This side is referred to as the
"Operator Side" because when mounted in the exoskeleton, it matches the
operator side of the camera. When controlling camera features, you'll also be
looking at all the Ki Pro control features for ease of use.
Buttons
Power ON/OFF Button—Controls system power on/off and shows whether power
is ON (when illuminated) or OFF. To turn power on, press the button once.It
isn't necessary to press hard or depress the button—it's a "soft" button sensed
by the processor inside. When OFF, and the button is touched, it will begin
powering up and display start-up progress on the alphanumeric display.
To power down, you must press and hold the power button down for 3
seconds. This action prevents accidental power-off during normal operation.
When the unit is powering down you can abort the power-down process by
simply removing your finger from the power button before 2 seconds have
elapsed.
STATUS Button—Pressing the STATUS button, when not lit, enters the I/O Status
menu. Repeatedly pressing the STATUS button will cycle through I/O Status,
Alarms, and Off (returning to the TRANSPORT menu). STATUS menus can be
accessed at any time—including when the machine is in an active transport
mode (PLAY, RECORD, FF, REV). The ALARM state displayed on the display
1 4% S
SELECT ADJUST
00:01:21:13
DELETE
SLOT
CLIP
Head
Phone
Volume
(Press in and
volume adjust
knob will pop out
for easy adjustment)
Slot LED Status Indicators show:
Media Selected—Green
Not-Selected—not illuminated
Recording—flashes Green, On and Off
Expresscard Memory Slots (2) — 34mm 1-lane PCIe
(press card in to mount; press again to eject)
Cover Plate
over WiFi
Antenna
4-pin XLR
Battery Power
Connector
(on side)
Head
Power
Phone
ON/OFF
Jack
(Press to power up,
press and hold for 5 seconds to
power-down; abort power-down
by removing finger before 5 seconds)