AJA Ki Pro Installation And Operation Manual page 26

Attaching the rod accessory kit is simple:
1. Place an endplate from the kit on the outside of the Exoskeleton frame, aligning
it's two screw slots with the two screw holes in the frame.
2. Insert one of the supplied screws from the inside of the frame through the frame
hole and slot. While holding the screw from the inside, screw one of the supplied
knobs on the threaded end of the screw.
3. Repeat step 2 for each of the 4 knobs and screws.
Once the kit is installed, you can then loosen the rod lock knobs, insert user-supplied
15mm accessory rods, and then mount any desired accessories.
To raise or lower the rods, simply loosen the rod height adjustment knobs (the ones
you installed in step 2), lift the rods to the desired height, and then tighten the knobs
once complete.
Exoskeleton Endplates and Rod Height Adjustment
Ki Pro Installation and Operation Manual — Installation
23
1