Transferring The System Program - Omron NT11S Operation Manual

Transferring the System Program

3-5

Transferring the System Program

Note
Transferring the system program from the system transfer tool
Reference
Operation 1. Connect the NT11S to the personal computer running the system transfer tool,
The system program of NT11S can be changed by the system transfer tool.
The system transfer tool is automatically installed in the personal computer when
the NT11S support tool is installed.
For details on how to start up the system transfer tool, and the system transfer tool
operation, refer to the NT-series NT11S Support Tool Operation Manual
(V030-E1-j).
An NT11S which has no system program registered in it will be able to execute
only installation function.
For details on system transfer tool operations, refer to the NT-series NT11S Sup-
port Tool Operation Manual (V030-E1-j).
In order to transfer the system program from the system transfer tool, first connect
the NT11S to a personal computer running the system transfer tool by using the
appropriate cable, then proceed as follows.
The NT11S uses one connector for the connection to both a PC and a computer. If
it has been connected to a PC, disconnect the PC and connect the system trans-
fer tool (computer) to the NT11S, and then, transmit the screen data.
then switch on the power to the NT11S.
2. Switch on the power to the personal computer and start up the system transfer
tool.
3. When the power to the NT11S is switched ON, the screen shown below is dis-
played.
System Program
isn't installed.
Press ENTER key
to start install
Section 3-5
51