Method For Making The Cable For Connection To The Pc - Omron NT11S Operation Manual

Method for Making the Cable for Connection to the PC

Method for Making the Cable for Connection to the PC
Explained below is the method for making the cable that connects the NT11S and the PC/Host.
Connect the wires to the connectors in accordance with the connector specification for each unit.
Making the Cable for Connection to the PC (RS-232C Type)
Parts Required
Two connectors, two connector covers and one cable are required to make up a connecting cable. One connector
and one connector cover is supplied with most PCs.
Name
XM2A-0901
Connector Connector
XM2A-2501
XM2S-0911
Connector Connector
cover cover
XM2S-2511
Connector XM2A-0901
Connector
XM2S-0911
cover
When connecting the NT11S to an OMRON PLC CjjH , the connector and the connector cover must be prepared
separately since they are not supplied with the CjjH.
The connector provided in the CPU unit of the CjjH is a 9-pin connector. For the connection, the following con-
nector and connector hood should be prepared.
S Connnector: XM2A-0901 (9-pin type, OMRON)
S Connector cover: XM2S-0911 (9-pin type, OMRON)
Prepare the cable recommended by OMRON.
The recommended cables are indicated in the following table.
Name
AWG28¢5P
IFVV-SB
Cable Cable
CO-MA-VV-SB
5P¢28AWG
146
Model
C series CQM1
C200H-LK201
C series CQM1
C200H-LK201
Type
APPENDIX D
Delivered with
—
—
Multiconductor shielded cable (FUJIKURA, Ltd.)
Multiconductor shielded cable (HITACHI Cable, Ltd.)
Remarks
9-pin, manufactured by OMRON
25-pin, manufactured by OMRON
9-pin, manufactured by OMRON
25-pin, manufactured by OMRON
9-pin, manufactured by OMRON
9-pin, manufactured by OMRON
Remark
Appendix D