Attach The Seat Frame To The Leg Press - Pacific Zuma Leg Press Option Assembly Instructions Manual

Zuma Leg Press Option Assembly Instructions
2. Attach the Seat Frame to the
Leg Press
A. Attach the Seat Frame to the Leg Press Base using
two 3¾-inch bolts
four washers
two locknuts
Wrench tighten.
B. Remove the Seat Bracket Support from the Seat
Frame. The holes in the Seat Bracket Support
should face up.
C. Lift the Pop Pin and slide the Seat Bracket Support
back through the Seat Frame. Lower the Pop Pin
and make sure that it engages into one of the holes
in the bracket.
D. Attach the Handle to the Seat Frame using
two 3-inch bolts
four washers
two locknuts
Wrench tighten.
E. Attach the Footrest to the Support Arm. Have an
assistant stabilize the Support Arm while you
attach the Footrest using
one ½-inch by 3½-inch large diameter bolt
two large ½-inch washers
one large ½-inch self-locking nut
Wrench tighten.
Step 2. Attach the Seat Frame to the Leg Press
Seat Bracket
Support
Pop Pin
Seat Frame
Flip the Seat Bracket
B
Support over so that the
holes face up.
D
Handle
2 - 3¾" bolts
A
4 - washers
2 - locknuts
Seat Frame
1 2
Footrest
C
1 - large ½" diameter by 3½" large bolt
E
2 - large ½" washers
1 - large ½" self-locking nut
2 - 3" bolts
4 - washers
2 - locknuts
3 4
Support Arm
Leg Press Base
5 6
page 8