Assemble The Pulleys - Pacific Zuma Leg Press Option Assembly Instructions Manual

Zuma Leg Press Option Assembly Instructions

4. Assemble the Pulleys

Important: If the Multi-Hip Option is attached to the
Zuma, remove the bolt that secures the top of the Cross
Brace to the Main Upright prior to mounting the Pulley
Plate. Replace the bolt with a 3¼-inch bolt instead of the
3-inch bolt used in step A.
A. Attach the top portion of the Pulley Plate to the
Main Upright using
one 3-inch bolt
two washers
one locknut
Wrench tighten.
Note: You may need to push in on the Padded
Handle to align the Pulley Plate mounting holes.
B. Attach the bottom edge of the Pulley Plate to the
Main Upright using
one 3-inch bolt
two washers
one locknut
Wrench tighten.
C. Mount one 3½-inch pulley to the top hole on the
Pulley Plate using
one 2½-inch bolt
one 3 / -inch barrel spacer
8
one 3½-inch cable retainer
one washer
one locknut
Finger tighten.
D. Mount one 4½-inch pulley to the bottom hole on the
Pulley Plate using
one 2½-inch bolt
one / -inch barrel spacer
3
8
one 4½-inch cable retainer
one washer
one locknut
Finger tighten. The illustration shows the proper
orientation and fastener alignment.
Step 4. Assemble the Pulleys
1 - 3" bolt
A
2 - washers
1 - locknut
Padded
crossbar
Pulley
plate
1 - 3" bolt
B
2 - washers
1 - locknut
4½" pulley
D
1 - cable retainer
1 - 2½" bolt
1 - washer
1 - 3 / " barrel spacer
8
1 - locknut
1 2
3½" pulley
C
1 - cable retainer
1 - 2½" bolt
1 - / " barrel spacer
3
8
1 - washer
1 - locknut
3 4 5
3½"
pulley
Cable retainer for
3½" pulley
Cable retainer for
4½" pulley
4½" pulley
6
page 10