Assemble The Seat Pads - Pacific Zuma Leg Press Option Assembly Instructions Manual

Zuma Leg Press Option Assembly Instructions

3. Assemble the Seat Pads

Note: Make sure that the seams on the Seat Pads face
toward the frame.
A. Determine which Seat Pad you want to use as the
Backpad. Attach it to the Seat Bracket Support
using
two 1¾-inch bolts
two washers
Wrench tighten.
B. Lift the Pop Pin and slide the Backpad out of the
way to mount the other Seat Pad.
C. Attach the Seat Pad to the Seat Frame using
two 2¾-inch bolts
two washers
Wrench tighten.
D. In preparation for assembling the pulleys, lower the
Support Arm so that it rests on the floor.
Step 3. Assemble the Seat Pads
Lift the Pop Pin
B
to slide the
Backpad out of
the way.
C
Support Arm
Lower the Support Arm
D
prior to the Pulley Plate
installation.
1 2
Backpad
2 - 2¾" bolts
2 - washers
Note: The Leg Press is not
shown in this illustration.
3 4
Seat Pad
Seat Bracket
Support
2 - 1¾" bolts
A
2 - washers
Pop Pin
Handle
Seat Frame
5 6
page 9