Sd Card Slot Access For Bracket-Mounted Routers - Cisco 1240 Hardware Installation Manual

Chapter 4 Mounting the Router
D E C . 2 0 1 1 — E F T R E V I E W D R A F T — C I S C O C O N F I D E N T I A L
Figure 4-14

SD Card Slot Access for Bracket-Mounted Routers

When the Cisco mounting bracket is attached the router according to the instructions in this chapter, the
bracket blocks access to the SD card port slot the router exterior.
To access the SD card slot (
that uses the bracket, take these steps and refer to
One one side of the router, remove the three bolts shown in
Step 1
Loosen but do not remove the fourth bolt that is inserted in the quick hang slot.
Step 2
Repeat
Step 3
Tilt the bracket on the quick mount slot, as shown in
Step 4
Be sure to reinstall and tighten all eight bolts when you finish using the SD card slot. The router must
Caution
be securely attached to the mounting bracket with four bolts on each side.
OL-12345-01
Attach Remaining Bolts to Bracket and Router
1 ) without removing the router from the bracket or any mounting installation
Step 1 through Step 2 on the other side of the router.
Figure 4-15:
Figure
Figure 4-15.
Cisco 1240 Connected Grid Router Hardware Installation Guide
Mounting Instructions
4-14.
4-17