Cisco 1240 Hardware Installation Manual page 70

Mounting Instructions
D E C . 2 0 1 1 — E F T R E V I E W D R A F T — C I S C O C O N F I D E N T I A L
What You Need
Mounting plate, carriage bolts, and clamp brackets included in the
•
Socket wrench that you provide.
•
Select a mounting location on the pole and place the top and bottom pole clamp bracket (1) notches
Step 1
against the pole.
Place one of the clamp brackets (
Step 2
with the top two carriage bolt holes on the mounting plate.
Insert a carriage bolt (
Step 3
through the holes in the clamp brackets.
Position the each bolt in the clamp so that the bolt is next to the pole, as shown in
Step 4
Follow these steps to place the bracket hardware on each carriage bolt, as shown in
Step 5
Place the washer (
a.
Thread the hex nut (
b.
and the nut.
Figure 4-6
Step 6 Hand tighten the hex nuts (do not overtighten).
Repeat
Step 7
the bottom of the mounting plate.
Step 8 Position the mounting plate and clamp brackets on the pole as needed before further tightening the
carriage bolts.
Cisco 1240 Connected Grid Router Hardware Installation Guide
4-8
1
) through each of the top two carriage bolt holes on the mounting plate and
5
) and then the split lock washer (
2
) on each carriage bolt. The split lock washer should be between the washer
4
Carriage Bolt Hardware Detail
Step 3 through Step 6, installing the two bottom carriage bolts and the second clamp bracket at
) on the opposite side of the pole, aligning the clamp bracket holes
) on the back of each carriage bolt (
3
Chapter 4 Mounting the Router
Pole Mount Kit.
Figure 4-6.
Figure 4-6:
).
5
OL-12345-01