Pioneer HTZ-BD52 Operating Instructions Manual page 74

80 Advanced settings
En
Adjusting the video
1. Select and set Display Setting
Adjust Next Screen.
Use / to select, then press ENTER.
2. Select the item and change the setting.
Use / to select the item, then use /
to change the setting. Once the setting is
completed, press
settings screen.
Item Description
Brightness Select this to adjust the TV screen's
brightness.
Contrast Select this to adjust the TV screen's
contrast.
Hue Select this to adjust the color (green
and red) balance of the TV screen.
Saturation Select this to adjust the TV screen's
saturation.
Adjust speaker settings
1. Select and confirm Audio Output
Speaker Setup
2. A picture of speakers will be shown on
the screen. Select the speaker using
cursor and press ENTER.
3. Use / to select Trim or Delay and
then press ENTER.
4. Use cursor / to adjust the setting,
then press ENTER.
Adjust speaker settings while listening
to a sound
1. Select and confirm Audio Output
Test Tone Next Screen.
2. A test tone will be output. The speakers
8
will switch automatically.
3. A picture of speakers will be shown
on the screen. Press ENTER when
the speaker you wish to adjust to is
focused.
4. Use / to select Trim or Delay and
then press ENTER.
5 Use / to adjust the setting, then press
ENTER.
Video
RETURN to close the
Next Screen
Setting the IP address
1. Select and set Network
Next Screen.
Use / to select, then press ENTER.
2. Set IP address.
Use / / / to set the IP address of the
player or DNS server, then press ENTER.
Auto Set IP Address
On – The player's IP address is obtained
automatically. Select this when using
a broadband router or broadband
modem that has a DHCP (Dynamic Host
Configuration Protocol) server function.
This player's IP address will automatically
be allocated from the DHCP server.
Off – The player's IP address must be set
manually. Use the number buttons (0 to
9) to input the IP address, subnet mask
and default gateway.
Note
For information on the DHCP server function,
refer to the operating instructions for the
network device.
You may need to contact your Internet service
provider or network administrator when
inputting the IP address manually.
IP Setting