Wireless Network Connection; Wireless Network Setup - Pioneer HTZ-BD52 Operating Instructions Manual

48 Connecting
En

Wireless network connection

Another connection option is to use an
Access Point or a wireless router. The network
configuration and connection method may vary
depending on the equipment in use and the
network environment.
This player is equipped with an IEEE 802.11n
(Single band, 2.4 GHz band) wireless module,
2
which also supports the 802.11b/g standards.
For the best wireless performance, we
Fi network (access point or wireless router).
Wireless
Communication
Broadband
service
Refer to the setup instructions supplied with
your access point or wireless router for detailed
connection steps and network settings.
For best performance, a direct wired connection
from this player to your home network's router
or cable/DSL modem is always the best option.
If you do chose to use the wireless option, note
that performance can sometimes be affected
by other electronic devices in the home.
PC and/or
DLNA certified server
Access Point or

Wireless network setup

For the wireless network connection, the player
needs to be set up for network communication.
This adjustment can be done from the [Setup]
menu. Adjust the [NETWORK] setting as follow.
Setting up the access point or the wireless
router is required before connecting the player
to the network.
Preparation
Before setting the wireless network, you need
to:
- connect the broadband internet to the
wireless home network.
- set the access point or wireless router.
- note the SSID and security code of the
network.
1. Select [Initial Setup]
[Interface] [Wireless] and press ENTER.
2. Select [Initial Setup]
[Wireless Setting] [Next Screen] and
press ENTER.
3. Select [Yes] and press ENTER to continue.
The new connection settings reset the
current network settings.
4. [Wireless Setting] menu is displayed.
Use / to select [Scan]. Then select [Next]
using the / and press ENTER.
5. The player scans the all available access
points or wireless routers within range and
display them as a list. Use / to select an
access point or wireless router on the list,
and then press ENTER.
If you have security on your access point
matches the router's information exactly.
You need to input the security code as
necessary.
6. Use the direction button, select the
password, the button upon the Clear can
change it to capital letter, lower case or
symbol. Press the Enter end it. Select the
Next button.
7. If it connects success, it will display
connection success and IP is obtained.
[Network]
[Network]