Siemens COMBIMASTER 411 Getting Started Manual page 5

1.1.3 Installation of Cable Glands
WARNING
MICROMASTER 411/COMBIMASTER 411 is not suitable for
connection to rigid conduit systems. Use flexible cables (CY and SY
types) for motor output and flexible cables or flexible conduit for mains
input or control connections.
Before power and control cables can be connected to their respective
circuits it will first be necessary to fit the cable glands supplied.
Each gland should preferably be located to allow for convenient cable
runs to the terminals located on the Filter and I/O boards.
Using a hammer as
shown opposite strike
the gland plate or
'knockout' to obtain a
clearance for the 25
mm cable gland.
Remove any sharp
edges from the gland
area and any swarf
from the terminal
housing.
After the knockout has
been removed it
should be safely
discarded and the
cable glands fitted as
shown in the assembly
diagram opposite.
MICROMASTER 411 & COMBIMASTER 411
Getting Started Guide – 07/05
B
A
1
1
2
A
B
Terminal housing
Figure 1 Installation of Cable Glands
B
A
2
5