Installation; Installation To Motor - Siemens COMBIMASTER 411 Getting Started Manual

1

Installation

WARNINGS
THIS EQUIPMENT MUST BE GROUNDED.
To ensure safe operation of the inverter, it must be installed and
commissioned by qualified personnel in full compliance with the
warnings laid down in the COMBIMASTER 411 and
MICROMASTER 411 operating instructions.
Take particular note of general and regional installation, and
safety regulations regarding work on dangerous voltage
installations (e.g. EN 50178), as well as the relevant regulations
regarding correct use of tools and personal protective gear.
Use Lifting Eyes provided if a motor has to be lifted. Do not lift
machine sets by suspending individual machines! Always check
Hoist capacity before lifting any equipment.
Do not paint over the black case finish of the inverter, as this will
affect the unit's thermal performance.
1.1

Installation to Motor

1.1.1 Preparation
The Installation Kit should comprise the following items:
Inverter cover
Terminal Housing
Filter Module & screws (captive)
Input – Output Board & screws (captive)
Earth Lead
10 Off Terminal Jumpers
2 off Glands M25 IP68 with O-ring
2 off M25 sealing plugs
2 off M25 Gland Fixing Plates
2 off U-clamp & screws (for earth/ground connection)
4 off M4 Inverter to Motor fixing screws (CSC only: additional 4 off
M5 screws)
Motor Cable Sheath
1 off Motor Gasket (CSC only: additional 1 off Motor Gasket)
1 off M12 connector blanking plug
Getting Started Guide and CD
Any defective or missing items should be reported immediately to your
local Siemens Distributor or Sales Office.
1.1.2 Installation Procedure
NOTE
MICROMASTER 411 ONLY:
Prior to installation it may be necessary to fit an Adaptation Plate to a
non-Siemens motor. The Adaptation Plate is prepared by the
respective motor manufacturer. Normally the Adaptation Plate makes
use of the existing motor gasket.
Physical dimensions and characteristics for installation of
MICROMASTER 411 are given in Section 2.3.3 and in Section 2.4.2
for COMBIMASTER 411 of the Operating Instructions.
MICROMASTER 411 & COMBIMASTER 411
Getting Started Guide – 07/05
3