Troubleshooting; Common Problems - Xantrex XPower 3000 Owner's Manual

Troubleshooting

This section describes the most common problems you may encounter with
the operation of the inverter along with resolutions.
If you encounter problems other than what is described in this section,
contact customer support at the number listed on "Contact Information" on
page i.

Common Problems

Buzz in Audio Equipment
Some inexpensive stereo systems may emit a buzzing noise from their
loudspeakers when operated from the inverter. This occurs because the
power supply in the audio system does not adequately filter the modified
sine wave produced by the inverter. The only solution is to use a sound
system that has a higher quality power supply.
Television Reception
When the inverter is operating, it can interfere with television reception on
some channels. If interference occurs, try the following:
1. Make sure that the chassis ground screw on the rear of the inverter is
solidly connected to the ground system of your vehicle or home.
2. Make sure that the television antenna provides an adequate ("snow-
free") signal, and that you are using good quality cable between the
antenna and the television.
975-0555-01-01
3. Keep the cables between the battery and the inverter as short as
possible, and twist them together with two to three twists per foot.
(This minimizes radiated interference from the cables.)
4. Move the television as far away from the inverter as possible.
5. Do not operate high power loads with the inverter while the television
is on.
Troubleshooting Reference
WARNING
ELECTRICAL SHOCK HAZARD
Do not disassemble, open, or repair the XPower Inverter 3000. It does
not contain any user-serviceable parts. Refer all servicing to qualified
service personnel.
Failure to follow these instructions can result in death or serious injury.
NOTE: See Table 1, "Troubleshooting Reference" on page 10.
9