Ignition Magic Cube 3d User Manual page 50

Troubleshooting
Magic Cube 3D
50
effect panel
Symptom
The unit does not work, no light
Apparently no function despite
proper power supply
No response to the DMX con-
troller
If the procedures recommended above do not succeed, please contact our Service Center. You
can find the contact information at www.thomann.de.
Remedy
Check the mains connection.
Check if the unit is in DMX mode or in 'slave' mode. If so,
check the unit in another mode.
1. Check whether the DMX controller is switched on.
Check the DMX connectors and cables for proper con-
nection.
2. Check the address settings and the DMX polarity.
3. Try using another DMX controller.
4. Check to see if the DMX cables run near or alongside
to high voltage cables that may cause damage or inter-
ference to DMX interface circuits.